Encore SP201-SA Bedienungsanleitung PDF herunterladen (Seite 13)

SP201-SA™ Installation Guide 13

E.6 Channel Configuration for NI2 ISDN

In the two-port SP201-SA, perform the following procedure once for trunk 2. In the four-port SP201-SA,

perform the procedure once each for trunks 3 and 4.

Note: If you are performing this procedure on a two-port SP201-SA, read trunk 3 as trunk 2.

What the terminal displays What you type What you are configuring

user> config dchans

ISDN signaling channel

The following is the present Trunk

configuration.

If a change to the Timeslot or

Interface Type is desired

Enter the Trunk number you wish to

modify or exit:

Trunk Signaling Timeslot Trunk Link Interface Protocol

Type Type State Type

-------------------------------------------------------------------------

3 D 24 T1 Inactive Network NI2 ISDN

4 D 24 T1 Inactive Network NI2 ISDN

ISDN Trunk Number

Enter value(3 - 4) or "exit" :

where p is the port

number (3 or 4) ISDN trunk p

Select interface type - user(0) or

network(1) : <current=1> 1 (or 0)

SP201-SA as the Network role

(or as the User role) in this

ISDN connection

ISDN Interface number 1 assigned to

Trunk

with a D Channel on timeslot 24.

Change ISDN Signaling Channel

Enter value(1 - 31; current="24") or

"exit" : 24

Signaling timeslot

(The following message appears only if you change

the channel number used as the signaling timeslot.)

Changes applied

The card must be reset for the

changes to operate properly

Do you wish to reset now (y/n)?

Delay in implementation of

changes until performing a

warmstart (described in

Section F, SP201-SA

Warmstart)

not resetting...

user>

(ISDN signaling has been

configured on this trunk.)

1 2 ... 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Encore SP201-SA Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern