Encore SP201-SA Bedienungsanleitung PDF herunterladen (Seite 31)

System Resets 2-31

SP201-SA™ Customization and Maintenance Guide

How to Use the coldstart Command

1 At the user> prompt, type coldstart and press Enter.

 The following prompt is displayed:

2 Do one of the following:

a If you want to reset all parameters on the SP201-SA, type y and

press Enter.

 The SP201-SA is re-initialized and is set to the default parameter

values. During the coldstart, the console displays the boot banner

and other information. After the SP201-SA has reset, the application

banner and the user> prompt are displayed.

b If you do not want to reset the parameters, type n and press Enter.

 The coldstart command is aborted. The user> prompt is

displayed.

2.4.4 The restorecfg Command

The restorecfg command retrieves a configuration from flash memory. (To

save a configuration into flash memory, see Section 2.4.2, The savecfg

Command.)

The restorecfg command is run during monitor mode. You can reach this

mode by performing a warmstart or a coldstart, as described in the

following procedure.

Coldstarting will reset all user definable parameters to their

factory defaults and drop any calls that are in progress.

Do you really want to coldstart? (y/n):

1 2 ... 26 27 28 29 30 31 32 33 34

Keine Kommentare

Encore SP201-SA Bedienungsanleitung Seite 31